Products Features
- SMOOTH WALL DESIGN: Provides contact along length of expansion area; provides consistent holding values; aesthetic appeal
- INTERNAL NATIONAL COARSE THREADS: Common threads create easier selection of threaded rod or bolt
- IDEAL FOR FLUSH MOUNTING: Nothing protrudes above surface of the concrete once anchor is properly installed
- MOST CONSISTENT HOLDING VALUES: Can be used in solid concrete as an internally threaded concrete fastener
- SLOTTED BODY IS PRECISION MATCHED TO TAPERED EXPANSION PLUG: Ensures that the anchor is uniformly expanded to provide consistent holding value
Products specifications
| Bit Size | 5/8″ |
| Box Qty | 50 |
| Minimum Embedment | 2″ |
| Primary | Concrete only |
| Thread Type | 1/2″ – 13 |
| Minimum Edge Distance | 3-1/8″ |
| Minimum Fixture Hole Diameter (In Place) | 11/16″ |
| Minimum Fixture Hole Diameter (Hole Spotted) | 1/2″ |
| Inside Anchor Diameter-Bolt Diameter | 1/2″ |
| Outside Anchor Diameter | 5/8″ |
| Internal Thread Length | 13/16″ |
| Brand Name | CONFAST® |
| Maximum Torque | 20 ft./lbs. |
| Bolt Length | Fixture Thickness + Embedment Depth |
| 2000 PSI Concrete – Pull-Out (lbs.) * | 2328 |
| Length Measurement | End to End |
| Diameter | 1/2″ |
| Length | 2″ |
| Material | Carbon Steel Zinc Plated |
| Environment | Dry |
| Type | Female |
* Values shown are average ultimate values and are offered only as a guide and are not guaranteed. A safety factor of 4:1 or 25% is generally accepted as a safe working load Application Video Installation Video Installing a 1/2″ Drop-In Anchor Zinc Plated
- Drill a 5/8″ hole into the concrete using a carbide-tipped bit that meets ANSI Standards B212.15.
- The depth of the hole can be deeper or equal to the minimum embedment depth of 2″ which is equal to the length of the anchor .
- Clean the hole with a wire brush, vacuum, compressed air, or a blow-out bulb.
- Insert the anchorinto the hole with the open threaded end facing up.
- Take the correct 1/2″ Drop-In Anchor Zinc Plated setting tool and insert the smaller diameter end into the threaded portion of the 1/2″ Drop-In Anchor Zinc Plated.
- Strike the end of the setting tool with a hammer until the anchor is fully set.
- The 1/2″ Drop-In Anchor Zinc Plated is now set. A 1/2″ diameter threaded rod or a bolt can be inserted into it with a maximum torque of 20 ft. lbs.
- Always use proper personal protective equipment per manufacturer’s and OSHA instructions.
Application Photos
